RF & Microwave Industry News

RSS

MATERIAL Cyanate Ester Resin The type EX-1515 cyanate ester resin system achieves full cure when processed at a temperature of 250°F and is characterized by its high radiation resistance, low moisture absorption, low dielectric and low loss properties required in many radar and RF transparent applications. Typical dielectric constant...

SYSTEM 800 MHz Repeater This repeater is now available for analog, CDMA and TDMA 800 MHz systems in two different 800 MHz versions. The first model has an adjustable bandwidth from 0.5 to 16.9 MHz. The second version is adjustable for both the primary and extended A and B...

PROCESSING EQUIPMENT High Speed, Ultra-precision Semirigid Cable Saw This saw is designed to perform precise cutting of semirigid coax cable. The tool can trim or cut cable to a tolerance of 0.0005" in less than two seconds and without leaving any burr on the cable. A precision slide mechanism...

ANTENNAS INMARSAT 4' Antenna The model AS48-15C/D INMARSAT 4' antenna with radome is designed for fixed-site applications for high wind requirements. The unit operates over a frequency range of 1525 to 1660 MHz, consists of a 4' reflector and circular-polarized L-band feed with a conical radome and is supported...

AMPLIFIERS Ultra-broadband Limiting Amplifier The model ADC-LA-0218 ultra-broadband limiting amplifier covers the 2 to 18 GHz frequency range and features dual in-phase RF outputs. Standard units operate from -20° to 70°C and feature +/-0.75 dB saturated output power across both frequency and temperature. In addition, Psat is +16 dBm...

DEVICES Zero-bias Schottky Diode The model ASI-3486 zero-bias Schottky diode is designed as a replacement part for the recently discontinued Hewlett-Packard model HSCH-3486 and M/A-COM model MA4E928B-54 zero-bias units. The silicon diode features hermetic glass packaging and is designed for high sensitivity applications up to 10 GHz. The unit...

SOURCES Rubidium Frequency Source The Rhino series portable rubidium-based frequency source is designed for both field andlaboratory utilization. Outputs for CDMA equipment include 19.6608 MHz, 1 PPS, phase-adjustable 1 PPS and 1/2 PPS synchronized to UTC. The frequency source includes eight buffered 10 MHz outputs with rubidium standard stability....

INTEGRATED CIRCUITS 2.4 - 2.5 GHz WLAN Chipset The Waverider 2 series wireless local area network (WLAN) chipset operates in the 2.4 to 2.5 GHz ISM band and consists of a wireless data controller (model WL102B), 2.4 to 2.5 GHz RF and IF circuit (model WL600C) and 2.5 GHz...

TEST EQUIPMENT Signal Analyzers The FSIQ series signal analyzers offer fully integrated spectrum, modulation and time analysis for wideband CDMA applications and wireless standards, including GSM, IS-136 and IS95-CDMA. Three models are available with different frequency bands, including the 20 Hz to 3.5 GHz model FSIQ3, 20 Hz to...

SUBSYSTEMS Receive Switch Matrix The SWRxxx series receive switch matrix is designed for use in relay cell local multipoint distribution service wireless systems where two receivers are used. The unit provides monitoring of the receiver's critical operating parameters and provides microprocessor-controlled automatic switching to a hot-standby receive path. The...