Articles by RFMW

The SiT5008 TCXO offers ±2 ppm stability and low-power consumption in a small industry-standard package that is pin-compatible with traditional quartz TCXOs, enabling 100 percent drop-in replacement without redesign or layout changes. 

The CMX90A003 and CMX90A004 are two-stage, fully matched MMIC PAs for use in 860 to 960 MHz, license-free bands with high efficiency (49 percent PAE) and gain (30 dB). 

QPF4550 integrates a 5 GHz PA, single pole two throw switch  and bypassable low noise amplifier into a single device. 

The PSF42B04S interdigital filter has a pass band of 40 to 44 GHz with 50 Ω characteristic impedance. Handling a maximum input power of 2 Watts, this SMT filters’ insertion loss is < 2.2 dB and boasts > 30 dB upper and lower bandpass rejection.

The SiT5356 series oscillators deliver ±100 ppb stability performance and can be factory-programmed to any combination of frequency (from 1 to 60 MHz), voltage and pull range.

The R1920SMUA5CR  delivers -121 dBc/Hz typical phase noise at 10 KHz offset at its operating range of 1920 MHz.

MT3A-0113HPA delivers exceptional IMD suppression with low conversion loss and high IP3, RF and LO input frequencies. 

The Qorvo QPA2309 power amplifier offers 100 W of pSat RF power from 5 to 6 GHz in a small 7 x 7 mm QFN package. 

The 40AH-03 is a 2.92 mm male to 2.92 mm female attenuator with 3 dB nominal attenuation from DC to 40 GHz.